Our site is not fully compatible with Internet Explorer. We strongly suggest using Google Chrome, Firefox, Safari, or Edge.

How to Set Up Flex Fuel

August 28, 2024

Configuring Flex Fuel on your FuelTech ECU is key to optimizing your engine's performance when running different ethanol blends. In this detailed guide, we’ll show you how to set up Flex Fuel, enabling your ECU to automatically adjust fuel and ignition parameters based on ethanol content. Whether you're switching between E85 and pump gas or fine-tuning for maximum efficiency, proper Flex Fuel setup ensures your vehicle runs smoothly and efficiently. Follow our step-by-step instructions to harness the full potential of your FuelTech system.

To properly set up Flex Fuel on your FuelTech ECU, it's essential to install a FuelTech Flex Fuel Sensor. This sensor measures the ethanol content in your fuel, allowing the ECU to make real-time adjustments to fuel delivery and ignition timing. Without the Flex Fuel Sensor, your ECU won't have the necessary data to optimize performance across different ethanol blends.

PRODUCTS YOU WILL NEED:

👉 FLEX FUEL SENSOR W/ CONNECTOR KIT

1. Open the FTMANAGER software and open Map Options in the task bar.

2. Once you have a Flex Fuel Sensor wired to your ECU, enable the Flex Fuel Function.

3. Under the other functions tab, select Flex Fuel and choose the Ethanol Content % the ECU will default to if the sensor fails.

4. Click on the Flex Fuel Wizard to choose your starting reference point. This will use the sensor to choose your starting point based on current ethanol content.

5. Next, navigate to Main Fuel Injection Compensation and adjust the table based on ethanol content to get the correct fueling.

6. Adjust your Engine Start and Prime Pulse Compensation based on ethanol content to get the proper starting fuel at any ethanol content.

7. Next, adjust your Acceleration Fuel Enrichment Compensation based on ethanol content so the car revs clean and has good throttle response at any ethanol content.

8. Click O2 Closed Loop Target Compensation. Here you can adjust your target lambda or AFR based on ethanol percentage. This allows richer or leaner mixtures to be targeted if needed.

9. Next, adjust your main ignition compensation based off of ethanol percentage. This allows your to add or subtract ignition timing to your main timing Map based on ethanol content.

10. Finally, you can add or remove Wastegate Pressure based on your ethanol percentage. This allows you to run higher boost when you have more ethanol content if desired.

Also in Tech Support Articles

How to Set-Up the Multifunction Button

August 29, 2024

By properly setting up the Multifunction Button on your FuelTech ECU, you’ll gain precise control over critical functions like line lock, staging, and boost + scramble, ensuring your vehicle is ready for the track. This configuration allows you to maximize performance, streamline your racing setup, and focus on what matters most, winning!

How to Set Up a 4L80E or 4L85E Transmission with FTManager

August 29, 2024

Setting up your 4L80E or 4L85E transmission with FTMANAGER delivers precise and reliable transmission control. In this guide, we’ll walk you through the necessary steps to configure your FuelTech ECU for seamless integration with these powerful GM transmissions.

How to Set Up a 4L60E or 4L65E Transmission with FTMANAGER

August 29, 2024

Setting up your 4L60E or 4L65E transmission with FTMANAGER provides precise and reliable transmission control for your vehicle. In this step-by-step guide, we’ll walk you through how to configure your FuelTech ECU for seamless integration with these popular GM transmissions.