Our site is not fully compatible with Internet Explorer. We strongly suggest using Google Chrome, Firefox, Safari, or Edge.

Missing Tooth Trigger Wheel

April 06, 2020

PRODUCTS YOU WILL NEED:

👉 ANY POWERFT ECU

1. Put the engine at top dead center cylinder number 1

2. Rotate the engine counterclockwise until the magnet/tooth that is just before the missing magnet/tooh lines up with your crank trigger sensor.

3. Now, look at what your timing pointer says and enter that number into the crank index position in the software.

4. Next, index your CAM Sync sensor.

5. For this, put the engine back to top dead center cylinder number 1.

6. Then rotate the engine counterclockwise to 90 degrees before top dead center.

7. Install your Cam Sync Sensor.

8. Align the Cam Sync Sensor with the magnet or tooth.

9. Enter 90 degrees in the Cam index position on the software.

10. You are now ready to start the engine and check timing with a timing light.

11. With the engine running, click the ignition calibration button on the laptop.

12. Next, a small window will pop up with your index position and a locked timing value of 20 degrees.

13. Finally, use the Plus and Minus buttons to adjust the index position until the actual timing matches 20 degrees on the timing light.

Also in Tech Support Articles

How to Set-Up the Multifunction Button

August 29, 2024

By properly setting up the Multifunction Button on your FuelTech ECU, you’ll gain precise control over critical functions like line lock, staging, and boost + scramble, ensuring your vehicle is ready for the track. This configuration allows you to maximize performance, streamline your racing setup, and focus on what matters most, winning!

How to Set Up a 4L80E or 4L85E Transmission with FTManager

August 29, 2024

Setting up your 4L80E or 4L85E transmission with FTMANAGER delivers precise and reliable transmission control. In this guide, we’ll walk you through the necessary steps to configure your FuelTech ECU for seamless integration with these powerful GM transmissions.

How to Set Up a 4L60E or 4L65E Transmission with FTMANAGER

August 29, 2024

Setting up your 4L60E or 4L65E transmission with FTMANAGER provides precise and reliable transmission control for your vehicle. In this step-by-step guide, we’ll walk you through how to configure your FuelTech ECU for seamless integration with these popular GM transmissions.